Pyro Industries Quest Plus Instrucciones de operaciones descargar pdf (Pagina 25)

Installing Your Insert Pellet Stove

INSERT STOVE VENTING

single-wall, stainless steel flexible or rigid exhaust pipe may be used for insert installa-

tions in place of double-wall, type

"L"

vent. The pipe should be connected to the supplied

clean-out tee.

High-temperature silicone sealant

should be used at the vent pipe connections to

ensure a "gas-tight" seal.

When venting through an existing chimney (masonry or factory built) the chimney must be

cleaned. All creosote, dust and ash must be removed (see page

for more information on

preparing the fireplace for the insert installation).

The

"L"

vent or single wall stainless exhaust system

must be installed so as to be gas-tight!

The vent manufacturer's installation procedures must be followed. In addition, pipe connections,

joints and

all

pipe seams within the home should be sealed with high-temperature, vulcanized

silicone sealer

(RTV).

an insert is to be installed into an unlined masonry chimney, the

rigid or flex pipe

must be extended

the top of the existing chimney. Fully lining the chimney in this man-

ner must be done whenever the integrity of chimney

in question for

any

reason.

After the chimney has been lined to the top of the existing flue, any opening between the exist-

ing chimney and the

pipelvent liner should be sealed with a metal plate. Use a clamp or other

fixture above the sealing plate to support the weight of the vent system.

See page

for

insert damper installation and operation

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 39 40

Sin comentarios

Pyro Industries Quest Plus Instrucciones de operaciones Pagina 25